Stormworks: Build and Rescue – Nuclear Reactor Guide

The Flow Chart What everything does

 
 
 
that is the flowchart explaining what every thing does first 
 
The fuel rods cannot be initially installed in the Nuclear fuel assembly while creating but can be installed later after the creation is spawned in. 
 
the nuclear fuel assembly is what holds the fuel rods and controls the reactor 
 
the boiler is what turns the water into steam 
 
the turbine uses the steam to create torque to spin a generator 
 
the steam condenser turns the steam back into water 
 
 

How it all works together

 
 
 
what happens when you submerge the fuel rod assembly with a rod inside it heats up the water around it we use this by pumping it to boilers coolant line causing it to heat up and pumping it back to the water around until the boiler hits 100 degrees and turns the water input into steam that is pumped to the turbine where it spins a thing of sorts and generates torque the any steam is pumped out into a steam condenser that turns it back to water to be used again 
 

I hope you enjoy the Guide we share about Stormworks: Build and Rescue – Nuclear Reactor Guide; if you think we forget to add or we should add more information, please let us know via commenting below! See you soon!