Stormworks: Build and Rescue – Alec’s Guide for Dissonance’s TU144

Disclaimer

Before we get started, please note that I take no credit for the making of this aircraft. All credit goes to Dissonance whose profile can be found https://steamcommunity.com/profiles/76561198327943757 and the aircraft that this guide has been created for can be found https://steamcommunity.com/sharedfiles/filedetails/?id=2017836066. This guide has been created simply as an alternative to the YouTube video tutorial created by Dissonance intended for those of us who prefer to have a checklist-style guide to refer to. This guide has been created solely off of the information gathered from the YouTube video, which can also be found https://www.youtube.com/watch?v=MkT4ca5hjlA. 
 
 
 

Starting the Aircraft

Engineer’s Panel 

• Bus Ties 1, 2, 3 ON 
• Battery Bus ON 
• Start Valve N1, N2, N3, N4 ON 
• Cross Feed 1, 2 ON 
• Main Tank 1, 4 ON 
• Forward Engineering Panel ON 
• Wing, Center Tank Auto Balance ON 
• Observe fuel gauges on overhead panel. Wait for them to balance out. 
• Wing, Center Tank Auto Balance OFF 
• Boost Pump N1, N2, N3, N4 ON 
• Gen Drive N1, N2, N3, N4 ON 
• Gen Bus N1, N2, N3, N4 ON 
• EEC N1, N2, N3, N4 ON 
• Afterburner N1, N2, N3, N4 ON 
• Hydraulic Pump N1, N2, N3, N4 ON 
• APU Start ON 
• Observe APU EGT and Generator Output and wait for these readings to stabilize.

 
Overhead Panel 

• Pack 1, 2 ON 
• Bleed Air N1, N2, N3, N4 ON 
• Upper Engineering Panel Lights ON

 
Center Console 

• Flaps ON 
• Transponder ON 
• Radar ON

 
Overhead Panel 

• Set lights as needed. 
• Aileron FLT Control ON 
• Rudder FLT Control ON 
• Elevator FLT Control ON

 
Center Console 

• Throttle 30.00 Idle

 
Overhead Panel 

• N1 Starter ON 
• N4 Starter ON 
• Isolation Valve ON

 
Engineer’s Panel 

• Observe N1 and N4 RPS and wait for them to stabilize.

 
Overhead Panel 

• N1 Starter OFF 
• N4 Starter OFF 
• N2 Starter ON 
• N3 Starter ON

 
Engineer’s Panel 

• Observe N2 and N3 RPS and wait for them to stabilize.

 
Overhead Panel 

• N2 Starter OFF 
• N3 Starter OFF 
• Isolation Valve OFF

 
Engineer’s Panel 

• APU Start OFF

I hope you enjoy the Guide we share about Stormworks: Build and Rescue – Alec’s Guide for Dissonance’s TU144; if you think we forget to add or we should add more information, please let us know via commenting below! See you soon!